Hayward VLX4007K Strainer Housing Kit – For VL40 Series Sand Filters
Part # VLX4007K — a replacement strainer housing kit designed for use with Hayward VL40T32 sand filters and compatible VL-series pool pump/filter setups.
Included Components
- Main strainer housing body
- Drain plug with O-ring seal
- Pump interlocking nut for secure assembly
Why It’s Needed
This kit replaces the original strainer housing assembly when it becomes cracked, warped, or otherwise damaged. A compromised housing can lead to leaks, loss of prime, reduced pump efficiency, or unsafe filtration operation. Installing a new VLX4007K housing restores the integrity of the pump’s suction chamber and ensures proper flow and sealing.
Typical Applications
Used for above-ground or VL-series sand filter systems — especially when the existing housing shows leaks, damage from impact or wear, or after extended filter service when the housing needs replacement. Also essential when rebuilding or refurbishing older sand filter setups to restore reliable performance.
Installation & Compatibility Notes
Before servicing, turn off pump power and fully relieve all system pressure. Drain water, remove old housing and components, and clean mating surfaces. Install new strainer housing, seat the O-ring correctly, install the drain plug and pump nut securely. Reassemble the system, refill and prime, then verify there are no leaks and that the filter/pump operates with proper flow and suction.
Maintenance & Inspection Tips
- Inspect the strainer housing periodically for cracks or stress lines — especially after winterization or heavy filter workloads.
- Ensure O-ring and drain plug remain in good condition and are properly seated each service cycle.
- Replace drainage plug O-ring or drain plug if leaking or showing signs of wear before re-amping the system.
- Keep a spare kit on hand for quick replacement to minimize downtime in case of housing failure.
