Hayward SPX3010C – 1 HP Impeller for Super II Pumps
Product Overview
The Hayward SPX3010C is a replacement impeller designed for Hayward Super II series pool pumps. It restores proper water flow and pump performance when the original impeller becomes worn or damaged.
Key Features
- Direct replacement for Super II series pump impellers.
- Supports 1 HP full-rated and 1.5 HP max-rated pump models.
- Precision-formed vanes for consistent hydraulic performance.
- Durable thermoplastic construction for long service life.
Technical Specifications
- Part Number: SPX3010C
- Pump Series: Hayward Super II (SP3000 series)
- Horsepower Match: 1 HP full-rated / 1.5 HP max-rated
- Material: Molded thermoplastic
Applications & Compatibility
This impeller is used in Super II series pumps typically found in in-ground pool systems. It is ideal for restoring performance when flow has decreased, the impeller is noisy, or vanes are cracked or obstructed. Always verify your pump model and horsepower rating before replacement.
Installation Instructions
- Shut off power to the pump and disconnect electrical supply.
- Remove the pump housing and drain any remaining water.
- Unscrew and remove the worn impeller from the motor shaft.
- Clean the shaft and install the new SPX3010C impeller securely.
- Reassemble the pump, prime the system and test for proper flow and quiet operation.
Troubleshooting
-
Low flow: Ensure the impeller is fully seated and check for suction restrictions.
-
Noise during operation: Confirm proper alignment of the housing and that no debris is contacting the impeller.
-
Motor overload: Verify correct impeller size for pump horsepower and check for plumbing blockages.
Maintenance Tip
Inspect the impeller during each pump service. Replace if the vanes are chipped, worn or obstructed. A healthy impeller maintains high flow efficiency and reduces strain on the pump motor.
