Hayward Sand Filter Compression Fitting Assembly | SPX1485DA

Hayward SPX1485DA Compression Fitting Assembly with Gasket (S200PAK3 / S240 Systems)

Hayward SPX1485DA is a genuine compression fitting assembly used on select Hayward sand filter systems to create a secure, watertight connection at the filter plumbing interface. This fitting includes the sealing gasket and is commonly referenced for Hayward ProSeries S200/S240 and certain system package variants.

Key Features

• Part Number: SPX1485DA
• Brand: Hayward
• Part Type: Filter parts – compression fitting assembly
• Includes gasket for leak-resistant sealing
• Used to restore a tight connection when the original fitting is cracked, leaking, or worn
• Common catalog/alternate references: 4800-43, 44130 (varies by listing)

Common Compatibility (Verify by Your Filter/System Model)

• Hayward ProSeries sand filter models: S200 and S240 (model/package dependent)
• Hayward system package references often listed: S240PAK2, S240PAK3, S200PAK2, S200PAK3

Common Reasons to Replace

• Dripping or seepage at the filter connection point
• Cracked fitting body or damaged compression surfaces
• Flattened, brittle, or missing gasket causing leaks
• Fitting will not tighten/seal consistently after service

Installation Notes

• Confirm this is the correct compression fitting style for your exact Hayward filter/system before ordering.
• Shut off the pump and relieve filter pressure completely before disassembly.
• Clean mating surfaces before installing the new fitting and gasket.
• Tighten evenly to achieve a seal—avoid overtightening plastic parts.
• After startup, inspect under normal operating pressure for any seepage.

Related Products

• Hayward SPX1485DA
• Hayward S200 Sand Filter Parts
• Hayward S240 Sand Filter Parts
• Hayward SX200EB Drain Pipe Assembly
• Hayward SX200K Dome Lid
• Pool Plumbing Fittings & Thread Sealants

Maintenance Tips

• Recheck fittings after the first run cycle—small seepage can appear once the system reaches full pressure.
• Support plumbing to reduce strain on the filter connection points and fittings.
• Replace worn gaskets promptly to prevent slow leaks that can damage pads and nearby equipment.